Inner Fascia Corner – RAL

Inner Fascia Corner – Steel

The inner fascia corner carries the fascia line around an internal angle in the elevation. Where two runs meet at a reflex corner – an L-shaped plan, a recessed entrance, a returning wing – this pre-formed piece makes the turn as a single component, so the mitre is factory-cut and consistent rather than fabricated on site with two cut ends butted together.

Pressed from steel and finished in RAL colours, it matches the rest of the hidden gutter fascia range, so the corner disappears into the run instead of drawing attention to itself. On a concealed gutter system the fascia is the visible element of the whole eaves detail, which makes a clean, square corner worth getting right – a hand-formed junction tends to show every millimetre of misalignment.

Key features

• Turns the fascia line through an internal (inward) corner
• Pre-formed component – no site mitring or fabrication required
• Profile and finish matched to the hidden gutter fascia range
• Suits L-shaped plans, recesses and returning elevations
• Lightweight at 0.176 kg – easy to hold in position while fixing

Specification

Count one corner for each internal angle on the elevation. Pair with the outer fascia corner where the plan turns the other way, and check that your fascia and corner colours match before ordering.