PVC 90° External Corner – Ø130, RAL

PVC 90° External Corner – Ø130, RAL 7016 & RAL 9005

The 90° external corner takes the gutter around a projecting corner of the building, joining two runs at a right angle. The angle is moulded in, so instead of mitring and sealing two cut gutter ends while working off a ladder, the corner drops into place with the geometry already correct.

Moulded in PVC for Ø130 half-round guttering on the 130/90 system, it pairs with the Ø90 downpipe range. The larger 130 mm profile suits bigger roof areas and steeper pitches, where the volume of water arriving at the eaves during heavy rain is more than a smaller gutter will carry. Being plastic, the corner needs no maintenance, will not corrode, and flexes with the seasonal movement of a long gutter run rather than working the joint loose.

Colours

Stocked in RAL 7016 anthracite grey and RAL 9005 jet black. Other RAL shades can be supplied to order – contact us for availability.

Key features

• Connects two gutters at 90° around an external building corner
• Pre-formed angle – no site mitring or cutting required
• PVC moulding: no corrosion, no repainting, colour throughout
• Fits Ø130 half-round gutter, system 130/90
• Available in RAL 7016 and RAL 9005; other colours to order
• Pair with the 90° internal corner where the plan turns inwards

Specification

Other RAL colours available on request – please contact us to check availability. Count one corner for each external angle on the roof plan, and check your gutter diameter before ordering – this fitting suits Ø130 only.